Lassco Spinnit HL-3 Paper Drill

The Lassco HL-3 (Hydraulic Lift - 3 Spindle) Paper Drill is a fully automatic hydraulic lift paper-drilling machine. It has an adjustable 2" or 2-1/2" drilling capacity and foot pedal control. The Lassco HL-3 Paper Drill has a powerful 1 HP spindle motor.

Features
The Lassco HL-3 (Hydraulic Lift - 3 Spindle) Paper Drill is a fully automatic hydraulic lift paper-drilling machine. It has an adjustable 2" or 2-1/2" drilling capacity and foot pedal control. The Lassco HL-3 Paper Drill has a powerful 1 HP spindle motor.

• Adjustable hydraulic lift speeds
• Easy set up for drill depth adjustment
• Three spindles with a 2-1/2 inch drilling capacity
• Fully automatic 1 HP hydraulic lift with foot pedal activation
• Powerful 1 HP spindle motor
• Sturdy adjustable back-gauge

• Table size: 17 x 32 inches
• Base footprint: 18 x 22 inches
• Table height: 36 inches
• Overall height: 56 inches
• Overall width: 32 inches
• Overall depth: 31 inches
• Max strokes per minute: 20
• Motor: 1 HP, 60 Hz, single phase 208/230 Volts, 7 Amps
• Receptacle required: NEMA L6-30R
• Actual weight: 510 lbs.
• Shipping weight: 640 lbs.
• Shipping dimensions: 48 x 40 x 60 inches
• Ships via: LTL Truck

• Two hand push button controls 

• Additional side guide
• Drill strips
• Hydrol HL hydraulic oil (15 liters)
• Style H hollow drill bits 

All floor model drills include:

• MS-1 drill sharpener
• Spin-Eze drill bit lubricant
• Set of 5/16 inch drill bits
• Sharpening stone
• Chip clearer

Some Pointers and Tips on Drilling: USE A SHARP DRILL BIT AT ALL TIMES. Generally, a Drill Bit can be used for approximately four (4) hours of use before it needs to be sharpened. Apply light pressure when sharpening. Too much pressure may cause flaring of the tip. (Once a Drill Bit has a flared tip, it becomes defective.) Three types of Drill Sharpeners are available. USE A SHARPENING STONE to debur the outside cutting edge of the your Drill Bits for better performance. LUBRICATE DRILL BITS OCCASSIONALLY - use Drill-Ease or Spin-Eze. While the drill is running, simply touch the Drill-Ease stick to the Drill Bit or brush on the Spin-Eze. This will allow for a smoother cut. USE DRILL BLOCKS. When drilling, a Drill Bit must stop slightly above the drill block when lowered. Replace worn out drill blocks regularly to ensure proper drilling.